Electrolux ERI635DSE, Manual

8

www.electrolux.com

4. CONTROLS

Button

Function

Led

L

Turns  the  lights  on/off  at  maximum  strength.

-

T1

Turns the motor on/off at speed one.

Fixed.

T2

Turns the Motor on at speed two.
Press and hold the button for approximately 3 seconds, 

with  all  the  loads  turned  off  (Motor  and  Lights),  to  turn  the 

Activated  Charcoal  Filter  alarm  on. The  relevant  LED  flashes 

twice  to  confirm.

To  turn  the  alarm  off,  press  the  button  again  and  hold  for  at 

least  3  seconds. The  relevant  LED  flashes  once.

Fixed.

T3

Turns the Motor on at speed three.
Press and hold the button for approximately 3 seconds, with 

all  the  loads  turned  off  (Motor  and  Lights),  to  perform  a  reset. 

The  LED  S1  flashes  three  times.

Fixed.

T4

Turns the Motor on at INTENSIVE Speed.
This speed is timed to run for 6 minutes. At the end of this 
time, the system returns automatically to the speed that was 

set  before.  If  it  is  activated  with  the  motor  turned  off,  the  hood 

will switch to OFF at the end of the time.

Fixed.

S1

Signals the Metal Grease Filter saturation alarm, indicating that 

it  is  necessary  to  wash  the  filters. The  alarm  is  triggered  after 

the Hood has been in operation for 100 working hours.

Fixed.

When this is activated, it signals the Activated Charcoal Filter 

saturation  alarm,  indicating  that  the  filter  must  be  changed; 

the Metal Grease Filters must also be washed. The Activated 
Charcoal Filter saturation alarm comes into operation after the 
Hood has been working for 200 hours.

Flashing.

5. LIGHTING

• Lamps in risk group 1 under 

IEC/EN62471 at a distance 
of 20cm and is exempt 
from risk group under IEC/
EN62471 at a distance of 
30cm.

•  For replacement contact techni-

cal support (“To purchase contact 
technical support”).