12 electrolux first use
The water softener must be set in
both ways: manually, using the water
hardness dial and electronically, using
some of the programme buttons on
the control panel
Setting manually
The dishwasher is factory set at
position 2.
1. Open the dishwasher door.
2. Remove the lower basket from the
dishwasher.
3. Turn the water hardness dial to
position 1 or 2 (see table).
4. Replace the lower basket.
Setting electronically
The dishwasher is factory set at
level 5.
1. Press the On/Off button. The
dishwasher must be in setting
mode.
2. Press simultaneously and keep
pressed buttons 2 and 3, until the
lights of buttons 1, 2 and 3 start
flashing.
3. Press button 1, the lights of
buttons 2 and 3 turn off while the
light of the button 1 goes on
flashing, at the same time the end
of programme indicator light
starts to flash.
The current level is indicated by
the number of flashes of the end
of programme indicator light (see
chart).
Examples:
5 flashes, pause, 5 flashes, pause,
etc... = level 5
6 flashes, pause, 6 flashes, pause,
etc... = level 6
4. To change the level, press function
button 1. Each time the button is
pressed the level changes. (For
the selection of the new level see
the chart).
Examples:
if the current level is 5, by pressing
function button 1 once, level 6 is
selected.
if the current level is 10, by
pressing function button 1 once,
level 1 is selected.
5. To memorise the operation, switch
off the dishwasher by pressing the
On/Off button.
156998 62/0en 21-08-2006 11:26 Pagina 12
Summary of Contents for ESF 64010
Page 1: ...user manual ESF 64010 Dishwasher ...
Page 2: ...We were thinking of you when we made this product ...
Page 43: ......
