Electrolux ESF 6720ROW, User Manual

Problem

Possible solution

Press 

Start

.

If the delay start is set, cancel the setting or
wait for the end of the countdown.

The appliance does not fill with
water.

Make sure that the water tap is open.

Make sure that the pressure of the water sup-
ply is not too low. For this information, con-
tact your local water authority.

Make sure that the water tap is not clogged.

Make sure that the filter in the inlet hose is not
clogged.

Make sure that the inlet hose has no kinks or
bends.

The appliance does not drain the
water.

Make sure that the sink spigot is not clogged.

Make sure that the drain hose has no kinks or
bends.

The anti-flood device is on.

Close the water tap and contact the Service.

After the checks are completed, activate
the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the
Service.
If the display shows other alarm codes,
contact the Service.

10.1 

If the washing and drying

results are not satisfactory

Whitish streaks or bluish layers on
glasses and dishes

• The released quantity of rinse aid is too

much. Adjust the rinse aid selector to a
lower position.

• The quantity of detergent is too much.

Stains and dry water drops on
glasses and dishes

• The released quantity of rinse aid is not

sufficient. Adjust the rinse aid selector
to a higher position.

• The quality of the detergent can be the

cause.

Dishes are wet

• The programme is without a drying

phase or with a low temperature drying
phase.

• The rinse aid dispenser is empty.

• The quality of the rinse aid can be the

cause.

• The quality of the combi detergent tab-

lets can be the cause. Try a different
brand or activate the rinse aid dispens-
er and use rinse aid together with the
combi detergent tablets.

Refer to ‘HINTS AND TIPS’ for
other possible causes.

10.2 

How to activate the rinse

aid dispenser

The activation of the rinse aid dispenser
can occur only with the Multitab option
activated.

1.

Press the on/off button to activate the
appliance.

2.

Press 

Reset

 for a few seconds.

3.

Press and hold, at the same time, 

De-

lay

 and 

AutoOpen

 until the indicators

 , 

 and 

 start to

flash.

4.

Press 

TimeSaver

,

•

The indicators 

 and 

 go

off.

ENGLISH

17