Electrolux ESF4510LOX, User Manual

5.1 Consumption values

Programme 1)

Water

(l)

Energy

(kWh)

Duration

(min)

9.5

0.789

225

6 - 11

0.5 - 1.2

40 - 140

11 - 13

1.0 - 1.2

130 - 150

7 - 8

0.9 - 1.0

50 - 60

8

0.8

30

4

0.1

14

1) The pressure and the temperature of the water, the variations of the mains supply, the

options and the quantity of dishes can change the values.

5.2 Information for test

institutes

For all the necessary information for test

performance, send an email to:

info.test@dishwasher-production.com
Write down the product number (PNC)

that is on the rating plate.

6. SETTINGS

6.1 Programme selection mode

and user mode

When the appliance is in programme

selection mode it is possible to set a

programme and to enter the user mode.
In user mode, the following settings

can be changed:

• The level of the water softener

according to the water hardness.

• The activation or the deactivation of

the acoustic signal for end of

programme.

• The activation or deactivation of the

rinse aid dispenser when you want to

use the Multitab option without rinse

aid.

These settings will be saved until you

change them again.

How to set the programme

selection mode

The appliance is in programme selection

mode when the programme indicator

 is on and the display shows the

programme duration.
When you activate the appliance, usually

it is in programme selection mode.

However, if this does not happen, you

can set the programme selection mode

in the following way:
Press and hold simultaneously Program

and Option until the appliance is in

programme selection mode.

6.2 The water softener

The water softener removes minerals

from the water supply, which would have

a detrimental effect on the washing

results and on the appliance.
The higher the content of these minerals,

the harder your water is. Water hardness

is measured in equivalent scales.

www.electrolux.com

8