Electrolux ESF6010BW, User Manual

           It is normal for a small amount of water to come out of the salt container.

1. The salt container must only be  refilled when the salt warning light in the control panel comes on. 
     Depending on how fully the salt dissolves, the salt warning light may still be on even though the 
     salt container is filled. 
     If there is no salt warning light in the control panel (For some Models),you can judge when to load 
     the salt into the softener by the cycles that the dishwasher had run.
2.  If there are spills of the salt, a soak or a rapid program should be run to remove the excess salt.

Always use salt intended for use with dishwasher.

The salt container is located beneath the basket and should be filled as follows:

Attention! 

Only use salt specifically designed for use in dishwashers! All other types of 
salt not specifically designed for use in a dishwasher, especially table salt, will 

salt the manufacturer does not give any warranty nor is liable for any caused 
damages. 

Only fill with salt just before starting one of the complete washing programmes.
This will prevent any grains of salt or salty water, which may have been split, 
remaining of the bottom of the machine for any period of time, which may cause
corrosion.

NOTE:

NOTE:

A

   Remove the basket and then unscrew and remove the cap from the salt container.

B

   Before first wash, add 1lt. of water  in the  salt container  of  your  machine.

C

   Place the end of the funnel (supplied) into the hole and introduce about 1kg of salt. 

D 

  After filling the container , screw the cap tightly back clockwise.

E

   Usually, the salt warning light will be cease to be illuminated within 2-6 days after the salt container has been filled with 

      salt.

F 

  Immediately after filling the salt into the salt container, a washing programme should be started (Suggest

 choose 

therwise filter system, pump or other important parts of the machine may be damaged by 

     salty water. It is out of warranty.

(Suggest

 choose 

NOTE:

NOTE:

If your model have no water softener, you may skip this section.

Step 1: Enter the status of salt adjustment

Adjusting Salt Consumption

Close the door, within 60 seconds after power on, press Start/Pause button and hold for 5 seconds,
 the machine will enter setting mode.

7

PRIOR USING FOR THE FIRST TIME

A

A.. 

 (fig.

)

1

1

 (fig.

)

2

2

   Quick 

programme). O

programme). 

damage the water softener. In case of damages caused by the use of unsuitable 

 Loading the SaIt Into the Salt container