Electrolux ESF6010BW, User Manual

Setting on the 

water softener

Digital display stalls

1

INTENSIVE 

2

3

4

5

dH

Water Hardness level

mmol/l

1)

2)

6

*

0-5

0-0.9

6-11

1.0-2.0

12-17

18-22

23-34

35-45

2.1-3.0

3.1-4.0

4.1-6.1

6.2-8.0

NORMAL

INTENSIVE

 & NORMAL

ECO

There are 6 levels of salt consumption in all.It is recommended to select the level according to below  table:

Step 2: select a certain level of salt consumption

Contact your local water board for information on the hardness of your water supply.

Contact your local water board for information on the hardness of your water supply.

Press the Start/pause button to select the proper set according to your local environment, 
     the sets will change in the following sequence: H1->H2->H3->H4->H5->H6;

Step 3: Exit the status of salt adjustment

Without any  operation in five seconds, the machine will exit from set mode, the machine is into standby status

Without any  operation in five seconds, the machine will exit from set mode, the machine is into standby status

1) German degree of measurement for the water hardness
2) millimol, internationel unit for water hardness

Note:

Note:

B. Fill the Rinse Aid Dispenser

B. Fill the Rinse Aid Dispenser

The rinse aid is released during the final rinse to prevent water from forming droplets on your dishes. That can leave 
spots and streaks. It also improves drying by allowing water to sheet off the dishes. Your dishwasher is designed to 
use liquid rinse aids. The rinse aid dispenser is located inside the door next to the detergent dispenser. To fill the 
dispenser, open the cap and pour the rinse aid into the dispenser until the level indicator turns completely black. 
The volume of the rinse aid container is about 110ml.

Rinse Aid Dispenser 

Function of Rinse Aid

Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying.

H1:

H1:

H2:

H2:

H3:

H3:

H4:

H4:

H5:

H5:

H6:

H6:

INTENSIVE

 & ECO

NORMAL & ECO

8

 *  factory setting