Electrolux ESF6767KXA, User Manual

29

INSTALLATION

General

•  When determining where to put your machine, 

choose a place where you can easily load and 

unload your dishes.

•   Do not put your machine in any location where  

there is a probability for the room temperature  

to fall below 0°C.

•   Before positioning, take the machine out of its 

packaging by following the warnings located on  

the package.

•  Position the machine close to a water tap or 

drain. You need to site your machine, taking into 

consideration that its connections will not be altered 

once they are made.

•  Do not grip the machine by the door in order to  

move it.

•   Leave a clearance on all sides of the machine so 

that you can comfortably move it back and forth 

during cleaning.

•   Make sure that the water inlet and outlet hoses 

aren’t squeezed while positioning the machine.  

Also, make sure that the machine does not stand  

on the electrical cable.

•  Adjust the machine’s adjustable feet so that it can 

stand level and balanced. Proper positioning of the 

machine ensures problem-free opening and closing 

of the door.

•   If the door of your machine does not close properly, 

check if the machine is stable on the floor it stands; 

if not, adjust the feet and ensure its stable position.

Location of services

All dishwasher services should be located in the cabinet 

next to the dishwasher opening.

Water connection

Connect the inlet hose to a water tap with an external 

BSP thread spout of 3/4”.
For best washing performance it is recommended to 

connect the appliance to a cold water supply. Energy 

savings can be made by connecting the appliance to a 

solar water system and using economy options, however 

the water temperature must not exceed 60°C.

 CAUTION!

Only turn the locking nut to secure the hose. Do 

not turn the hose.
Inlet water supply

•  Water pressure: 800kPa max – 50 kPa min.
•  Water flow rate 10 L/minute.
•  If water pressure is in excess of 800 k Pa, a pressure 

reducing valve should be used. Check for leaks.

•  If water temperature is in excess of 60°C, a 

tempering valve should be used. Check for leaks.

 CAUTION!

Always use new hoses when you connect the 

appliance to the water mains. Old hoses must not 

be used. The water inlet hose must be examined 

at an interval of twelve months for deterioration 

and replaced if necessary.

Remove entire plastic 

membrane from sink trap 

spigot and fit drain hose to 

spigot with clamp

The drain hose should not be extended 

by more than 2m otherwise water 

pump out problems could occur

min. 400mm  

straight section

400mm min.

power outlet

sink

600mm max.

300mm min.