Electrolux ESF6767KXA, User Manual

30  electrolux.com.au

INSTALLATION 

(CONTINUED)

Positioning the machine

When considering the location for the dishwasher, 

ensure that there is adequate space to enable loading  

and unloading of the dishes.
•  Do not put your machine in any location where  

the ambient temperature can fall below 5°C.

•  Before positioning, take the machine out of its 

packaging by following the warnings located on  

the package.

•  Position the machine close to a water tap and 

drain. You need to position your machine, taking 

into consideration that its connections will not be  

altered once they are made.

•  Do not grip the machine by its door or panel in  

order to move it.

•  Take care to leave a certain clearance from all sides 

of the machine so that you can comfortably move  

it back and forth during cleaning.

•  Make sure that the water inlet and outlet hoses do 

not get squeezed while positioning the machine. 

Also, make sure that the machine does not stand 

on the electrical cable. Adjust the machine’s feet 

so that it is level and stable. Proper positioning of 

the machine ensures problem-free opening and 

closing of its door.

•  If the door of your machine does not close properly, 

check if the machine is stable on the floor; if not, 

adjust the feet and ensure it is level and stable.

Water connection

Ensure that the indoor plumbing is suitable for installing 

a dishwasher and complies with AS/NZS 3500.1. Also, 

we recommend that you fit a filter at the entrance of 

your place or apartment so as to avoid any damage 

to your machine because of any contamination 

(sand, clay, rust etc) that might be 

occasionally carried in through the 

main’s water supply or the indoor 

plumbing, and to avoid problems of 

staining and formation of deposits 

after washing.

Water inlet hose

Do not use the water inlet hose of 

your old machine, you must use 

the new water inlet hose supplied with your machine. 

Before connecting the water inlet hose to the water 

tap, ensure clean water is flowing from the tap before 

making the connection. Connect the water inlet hose 

directly to the water inlet tap. The pressure supplied by 

the tap should be at a minimum of 0.03 MPa and at a 

maximum of 1 MPa. If the water pressure is above 1 

MPa, a pressure-relief valve should be installed.

WARNING

WARNING

Only turn the locking nut to secure hose – 

do not turn the hose.

•  The first time you use the appliance, make sure 

that there is no leakage.

•  The water inlet hose has a safety valve and a 

sheath with an inner mains cable.

•  After the connections are made, the tap should be 

turned on fully and checked for water tightness. 

For the safety of your machine, make sure to 

always turn off the water inlet tap after each wash 

program is finished.

WARNING

WARNING

NOTE: Aquastop inlet hose has 

components using 240V. Do not 

cut Aquastop inlet hose. Do not let 

it get folded, twisted, kinked 

or crushed.

WARNING

WARNING

NOTE: A water tempering valve is 

required if the water temperature  

is over 60°C.

WARNING

CAUTION

Always use new hoses when you connect the 

appliance to the water supply. Old hoses must 

not be used. The water inlet hose must be 

examined at an interval of twelve months for 

deterioration and replaced if necessary.
In order to pass the safety valve through the 

kitchen cabinets, an opening of at least 45mm x 

90mm is needed.

30cm  

min.