Electrolux ESI 67050, User Manual

of energy that are more environmentally
friendly as e.g. solar or photovoltaic panels
and aeolian).
For making the connection itself, the cou-
pling nut fitted to the appliance water inlet
hose is designed to screw onto a 3/4" thread
spout or to a purpose made quick-coupling
tap such as the Press-block.
The water pressure must be within the limits
given in the 'Technical data'. Your local Wa-
ter Authority will advise you on the average
mains pressure in your area.
The water inlet hose must not be kinked,
crushed, or entangled when it is being con-
nected.
The appliance features inlet and drain hoses
which can be turned either to the left or the
right to suit the installation by means of the
locknut. 

The locknut must be correctly

fitted to avoid water leaks.

Attention! NOT all dishwasher models of
have inlet and drain hoses provided with
a locknut. In this case, this facility is not
available.

If the appliance is connected to new pipes or
pipes which have not been used for a long
time, you should run the water for a few mi-
nutes before connecting the inlet hose.

DO NOT use connection hoses which
have previously been used on an old ap-
pliance.

This appliance has been fitted with safe-
ty features which will prevent the water
used in the appliance from returning
back into the drinking water system. This
appliance complies with the applicable
plumbing regulations.

Water inlet hose with safety valve

After connecting the double-walled water in-
let hose, the safety valve is next to the tap.
Therefore the water inlet hose is only under
pressure while the water is running. If the wa-
ter inlet hose starts to leak during this oper-
ation, the safety valve cuts off the running
water.
Please take care when installing the water
inlet hose:
• The electrical cable for the safety valve is

in the double-walled water inlet hose. Do
not immerse the water inlet hose or the
safety valve in water.

• If water inlet hose or the safety valve is

damaged, remove the mains plug imme-
diately.

• A water inlet hose with safety valve must

only be replaced by the Service Force
Centre.

Warning!

 Dangerous voltage

Water drain connection

The end of the drain hose can be connected
in the following ways:
1. To the sink outlet spigot, securing it to the

underside of the work surface. This will
prevent waste water from the sink run-
ning into the machine.

2. To a stand pipe provided with venthole,

minimum internal diameter 4 cm.

The waste connection must be at a maxi-
mum height of 60 cm from the bottom of the
dishwasher.

The drain hose can face either to the right or
left of the dishwasher
Ensure the drain hose is not bent or squash-
ed as this could prevent or slow down the
discharge of water.

electrolux 

 23