5.1
Consumption values
Programme 1)
Water
(l)
Energy
(kWh)
Duration
(min)
P1
9.9
0.932
195
P2
7 - 12
0.6 - 1.4
40 - 150
P3
13 - 15
1.3 - 1.5
140 - 160
P4
9
0.9
30
P5
4
0.1
14
1)
The pressure and the temperature of the water, the variations of the mains supply, the op-
tions and the quantity of dishes can change the values.
5.2
Information for test institutes
For all the necessary information for test
performance, send an email to:
info.test@dishwasher-production.com
Write down the product number (PNC)
that is on the rating plate.
6.
SETTINGS
6.1
Programme selection mode
and user mode
When the appliance is in programme
selection mode it is possible to set a
programme and to enter the user mode.
In user mode, the following settings
can be changed:
• The level of the water softener
according to the water hardness.
• The activation or the deactivation of the
acoustic signal for end of programme.
• The deactivation of the rinse aid
dispenser when you want to use the
Multitab option without rinse aid.
These settings will be saved until you
change them again.
How to set the programme
selection mode
The appliance is in programme selection
mode when the display shows the
programme number
P1
.
When you activate the appliance, usually it
is in programme selection mode.
However, if this does not happen, you can
set the programme selection mode in the
following way:
Press and hold
Reset
until the appliance
is in programme selection mode.
6.2
The water softener
The water softener removes minerals from
the water supply, which would have a
detrimental effect on the washing results
and on the appliance.
www.electrolux.com
28
