Electrolux ESS67300SW, User Manual

Water softener

level

Amount of water

(l)

8

5

9

3

10

3

In case of the high water softener setting,

it may occur also in the middle of the

programme, before the rinse (twice

during a programme). Regeneration

initiation has no impact on the cycle

duration, unless it occurs in the middle of

a programme or at the end of a

programme with a short drying phase. In

such cases, the regeneration prolongs

the total duration of a programme by

additional 5 minutes.
Subsequently, the rinsing of the water

softener that lasts 5 minutes may begin

in the same cycle or at the beginning of

the next programme. This activity

increases the total water consumption of

a programme by additional 4 litres and

the total energy consumption of a

programme by additional 2 Wh. The

rinsing of the softener ends with a

complete drain.
Each performed softener rinse (possible

more than one in the same cycle) may

prolong the programme duration by

another 5 minutes when it occurs at any

point at the beginning or in the middle of

a programme.

All the consumption values

mentioned in this section are

determined in line with the

currently applicable standard

in laboratory conditions with

water hardness 2.5mmol/L

(water softener: level 3)

according to the regulation:

2019/2022 regulation.

The pressure and the

temperature of water as well

as the variations of the

mains supply can change

the values.

How to set the water softener

level

Make sure the appliance is in user mode.

1. Press Programs.

• The indicators 

,   and

 are off.

• The indicator 

 still flashes.

• The display shows the current

setting: e.g. 

 = level 5.

2. Press Programs repeatedly to

change the setting.

3. Press on/off to confirm the setting.

6.3 The rinse aid empty

notification

The rinse aid helps to dry the dishes

without streaks and stains. It is

automatically released during the hot

rinse phase.
When the rinse aid chamber is empty,

the rinse aid indicator is turned on

notifying to refill rinse aid. If the drying

results are satisfactory while using multi-

tablets only, it is possible to deactivate

the notification for refilling rinse aid.

However, for best drying performance,

always use rinse aid.
If standard detergent or multi-tablets

without rinse aid are used, activate the

notification to keep the rinse aid refill

indicator active.

How to deactivate the rinse aid

empty notification

Make sure the appliance is in user mode.

1. Press Start.

• The indicators 

,   and

 are off.

• The indicator 

 still

flashes.

• The display shows the current

setting.

–

 = the rinse aid empty

notification is deactivated.

–

 = the rinse aid empty

notification is activated.

2. Press Start to change the setting.

ENGLISH

11