Electrolux EU 1323T, Instruction Booklet

12

Door reversal

Before carrying out the operations described below,
pull out the mains plug from the wall socket.
To carry out this reversal go through the following
steps:

1. Gently lay the appliance on its back with the top

held away from the floor by 5-8 cm (2-3 inches) of
packing.

2. Remove the bottom door hinge (5).

3. Remove the door (4) by opening it and pulling it

gently downwards to remove it from the top hinge
pin (2).

4. Unscrew the top hinge pin (2) from the top hinge (1)

and replace it in the opposite hole on the left hand
side.

5. Unscrew the foot at the base (6) of the appliance

and refit it on the opposite side.

6. Refit the door and the bottom hinge (5) to the left

hand side.

7. Unscrew the handle (3). Refit it on the opposite side

after having pierced the plugs with a punch. Cover
the holes left open with the plugs contained in the
documentation pack.

When positioning the bottom hinge blade on the
reverse side, the securing screws will require a
degree of exersion when fitting.
It is therefore advisable to lubricate the screw tips
before starting this operation.

Attention

After completion of the door reversing
operation, check that the door gasket adheres
to the cabinet. If the ambient temperature is
cold (i.e. in Winter), the gasket may not fit
perfectly to the cabinet. In that case, wait for the
natural fitting of the gasket or accelerate this
process by heating up the part involved with a
normal hairdryer on a low setting.