Electrolux EU 6233 I, Instruction Book

6

Making ice cubes

The appliance is provided with one or more plastic

ice cube trays.
Fill the tray(s) 3/4 full to give the ice space to expand

and place them in one of the freezer compartment.
To release the ice cubes simply give the tray a slight

twist. Do not use sharp or metallic instruments to

remove the trays from the freezer.

Thawing

Deep frozen or frozen food, prior to being used, can

be thawed in the fridge or at room temperature

depending on the time available. Small food items

may even be cooked from frozen; in this case

cooking will take longer.
Any frozen food which is allowed to thaw

accidentally should either be eaten as soon as

possible or thrown away. Alternatively, if the food is

uncooked and has not been completely defrosted it

can be cooked and then refrozen.

Defrosted cooked food must never be refrozen. 

Warning 

Do not put carbonated liquids, (fizzy drinks etc.), in

the freezer compartment.
Water ices, if consumed immediately after removal

from the freezer, can cause a low temperature skin

burn.
Do not remove items from the freezer if your hands

are damp/wet, as this could cause skin abrasions or

Òfrost/freezer burnsÓ.
In the event of a power cut the food in the freezer will

not be affected if the power cut is short and the

freezer is full. Do not open the door . Should the food

begin to thaw, it must be consumed quickly and must

not be re-frozen.

Frozen food storage

When you first start the freezer or if the freezer has

been out of use for some time, we advise you to run

your appliance for at least two hours in the Ç fast

freezeÈ mode before storing frozen food.
Do not exceed the storage period indicated by the

manufacturer.
Finally, do not open the door frequently or leave it

open longer than is absolutely necessary.

19

Press in the joint covers between the appliance and

the kitchen unit.

Apply covers (B) on joint cover lugs and into hinge

holes.

D724

D726

B

Place guide (A) on the inside part of the furniture

door, upper and lower position as shown in the figure

and mark the position of external holes. Having

drilled the holes, fix the guide with the screws

supplied.

20 mm

A

50mm

PR166

Separate parts A, B, C, D as shown in the figure

PR266

A

B

C

D