Electrolux EU 6233 I, Instruction Book

9

MAINTENANCE AND CLEANING 

Before any maintenance or cleaning work is carried

out, DISCONNECT the appliance from the

ELECTRICITY supply.

Internal cleaning

Clean the inside and accessories with warm water

and bicarbonate of soda (5ml to 0.5 litre of water).

Rinse and dry thoroughly.

NEVER USE DETERGENTS, ABRASIVE

POWDERS, HIGHLY PERFUMED

CLEANING PRODUCTS OR WAX

POLISHES, TO CLEAN THE INTERIOR AS

THESE WILL DAMAGE THE SURFACE AND

LEAVE A STRONG ODOUR.

When the appliance is not in use

When the appliance is not in use for long periods,

disconnect from the electricity supply, empty all

foods and clean the appliance, leaving the doors ajar

to prevent unpleasant smells.

External cleaning

Wash the outer cabinet with warm soapy water. Do

NOT use abrasive products.
Once or twice a year dust the condenser (black grill)

and the compressor at the back of the appliance,

with a brush or vacuum cleaner, see figure, as an

accumulation of dust will affect the performance of

the appliance and cause excessive electricity

consumption.

D273/1

CONDENSER

COMPRESSOR

16

INSTALLATION

Warning

IF YOU ARE DISCARDING AN OLD APPLIANCE

THAT HAS A LOCK OR CATCH ON THE DOOR,

YOU MUST ENSURE THAT IT IS MADE

UNUSABLE TO PREVENT YOUNG CHILDREN

BEING TRAPPED INSIDE.
Depending upon the position which you choose for

your appliance, you may wish to reverse the way in

which the door opens. To do this, refer to instructions

on ÒDoor reversal directionsÓ.

Positioning

This appliance should only be installed at a location

where the ambient temperature corresponds to the

climate classification indicated on the rating plate,

which is located on the inside left of the appliance.
The following table shows which ambient

temperature is correct for each climate classification. 
SN    +10¡C  to  + 32¡C
ST

+18¡C  to  + 38¡C

The appliance should be located in a dry

atmosphere, out of direct sunlight and away from

continuous heat and extreme temperature, e.g. not

next to a boiler or radiator, or in a very cold room e.g.

an outhouse. If these temperatures are exceeded i.e.

warmer or colder, then the appliance may not

operate correctly. 
For building-in and door reversal instructions please

refer to the relevant instructions on the following

pages.

Important

It must be possible to disconnect the appliance from

the mains power supply; the plug must therefore be

easily accessible after installation.