30
L
L
T
TR
RO
OU
UB
BL
LE
ES
SH
HO
OO
OT
TIIN
NG
G
L
L..1
1
C
Co
om
mm
mo
on
n ffa
au
ullttss
DISHWASHER DOES NOT WASH
WELL
1. Check if the suction filter is dirty and clean it thoroughly.
2. Check if the wash jets are clogged by solid food remains.
3. Check that the initial amount of detergent or subsequent additions are correct.
4. The selected wash cycle is too short. Repeat the cycle.
5. Check that the tank temperature is between 55 ℃ and 65 ℃.
6. Check that the dishes are stacked correctly in the racks.
GLASSES AND DISHES ARE NOT
DRIED PROPERLY
1. Check the instructions for the amount of rinse-aid (see H.2
Setting the dispensers
paragraph).
2. Check that there is rinse-aid in the container and if necessary top up.
3. Check the set amount of rinse-aid (see H.2
Setting the dispensers paragraph).
4. Check that the water temperature is between 80℃ and 90℃.
CONDENSATION ON GLASSES
1. Check that there is rinse-aid in the container and if necessary top up.
2. Check the set amount of rinse-aid (see H.2
Setting the dispensers paragraph).
3. Remove the rack of glasses immediately the cycle has ended.
STAINS ON THE GLASSES
1. Only use “non-foaming” products for professional dishwashers.
EXCESSIVE FOAM IN THE TANK
1. Check that the wash water temperature is not less than 50℃.
2. Check if the amount of product dispensed by the detergent dispenser is
excessive (see H.2
Setting the dispensers paragraph).
3. Ensure that the tank has not been cleaned with unsuitable cleaners. Drain the
tank and rinse thoroughly before new wash cycles.
4. If a foaming detergent has been used, drain and refill the tank with water until the
foam disappears.
SMEARS OR SPOTS ON THE
GLASSES
1. Reduce the amount of rinse-aid (see H.2
Setting the dispensers paragraph)
THE WASH OR RINSE ARMS TURN
SLOWLY
1. Remove and thoroughly clean the arms.
2. Clean the wash pump suction filter.
L
L..2
2
A
Alla
arrm
mss
A1
NO WATER
• Check that the tap is open.
• Check that the water inlet filter is clean.
• Check the minimum mains pressure.
• Check that the overflow pipe is inserted (only for appliances
without drain pump).
B1
INEFFICIENT DRAINAGE
• Check if the overflow has been removed.
• Check for obstruction on the waste outlet pipe and the
overflow aperture.
B2
TANK WATER LEVEL TOO HIGH
• Check for obstruction on the waste outlet pipe and the
overflow aperture.
C1 – C8
CALL THE SERVICE CENTRE
E1 – E8
CALL THE SERVICE CENTRE
• The appliance continues to operate, but appropriate checks
by a technician are recommended.
F21 – F22
1
CALL THE SERVICE CENTRE
• Resin regeneration cycles are not performed. The appliance
continues to operate without water softener.
1.
Only for appliances with incorporated continuous water softener.
