Electrolux EUF22390W, User Manual

Problem

Possible cause

Solution

The temperature in the
appliance is too low.

The Temperature regulator may
be set incorrectly.

Set a higher temperature.

The temperature in the
appliance is too high.

The Temperature regulator may
be set incorrectly.

Set a lower temperature.

The door is not closed correctly.

Refer to "Closing the door".

The food temperature is too high.

Let the food temperature decrease
to room temperature before stor-
age.

The temperature in the
freezer is too high.

Food is too near to each other.

Store food so that there is cold air
circulation.

Large quantities of food to be fro-
zen were put in at the same time.

Insert smaller quantities of food to
be frozen at the same time.

The appliance does not
operate.

The appliance is switched off.

Switch on the appliance.

The mains plug is not connected
to the mains socket correctly.

Connect the mains plug to the
mains socket correctly.

The appliance has no power.
There is no voltage in the mains
socket.

Connect another electrical appli-
ance to the mains socket. Check
fuse. Contact a qualified electri-
cian.

The door has been open to long.

Close the door.

A large quantity of drops
ice covers the top com-
partment inside the appli-
ance. .

There is too much frost and ice on
the evaporator of the appliance,
the door was open for too long
time.

Refer to "Cleaning the evaporator".

As much as the advice does not lead to result, call the nearest brand-mark service.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-

stallation".

3. If necessary, replace the defective door

gaskets. Contact the Service Center.

Cleaning the evaporator

1. Switch off the appliance.
2. Disconnect the mains plug from the

mains socket.

3. Remove all foods from the freezer and

put them in a fresh place.

4. Move the appliance far from the wall.
5. Leave the door open.
6. After approximately 20 minutes the drain

hose at the rear of the cabinet starts to
discharge water into the drip tray.

7. To prevent the water overflowing from

the drip tray dry with a sponge.

8. The defrosting process ends when the

water stops dripping. It may take several
hours if the problem started long before.

9. Move the appliance to the original posi-

tion.

electrolux 

 9