• The appliance must not be located close
to radiators or cookers.
• Make sure that the mains plug is accessi-
ble after the installation of the appliance.
• Connect to potable water supply only.
8)
Service
• Any electrical work required to do the
servicing of the appliance should be car-
ried out by a qualified electrician or com-
petent person.
• This product must be serviced by an au-
thorized Service Centre, and only genu-
ine spare parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer,
in either its refrigerant circuit or insula-
tion materials. The appliance shall not
be discarded together with the urban
refuse and rubbish. The insulation foam
contains flammable gases: the appli-
ance shall be disposed according to
the applicable regulations to obtain
from your local authorities. Avoid dam-
aging the cooling unit, especially at the
rear near the heat exchanger. The ma-
terials used on this appliance marked
by the symbol
are recyclable.
CONTROL PANEL
ACTION FREEZE
1 2
3
4
5
1
ON/OFF button
Pilot light
2
Temperature indicator
3
Temperature regulator button, + and -
4
Action Freeze button
Action Freeze light
5
Alarm reset button
Alarm light
Switching on
Insert the plug into the wall socket.
If the pilot light and the display is not illumi-
nated, press ON/OFF button.
Select a temperature according to "Tem-
perature regulation".
Important!
If the door remains open for
some minutes, the light will turn off
automatically. The light is reset by closing
and opening the door.
Switching off
To turn off the appliance, press the ON/OFF
button for approx. one second.
The pilot light will switch off.
Temperature regulation
The temperature can be adjusted between
-15°C and -24°C.
By pressing the Temperature regulators,
the current temperature setting flashes on
the Temperature indicator. It is possible to
modify the setting temperature only with
flashed indicator.
• To set a warmer temperature, press
Temperature reg.
• To set a colder temperature, press Tem-
perature regulator -.
The Temperature indicator displays the
newly selected temperature for a few sec-
onds and then shows again the inside com-
partment temperature.
The newly selected-temperature must be
reached after 24 hours.
Important!
After a long period out of use it
is not necessary to set again the
temperature because it remains stored.
A medium setting is generally the most
suitable.
8) If a water connection is foreseen.
electrolux
17
Summary of Contents for EUF31301W
Page 54: ...54 electrolux ...
Page 55: ...electrolux 55 ...