Problem
Possible cause
Solution
Temperature cannot be set. The FastFreeze or Shop-
ping function is switched
on.
Switch off FastFreeze or
Shopping manually, or wait
until the function resets au-
tomatically to set the tem-
perature. Refer to "Fast-
Freeze or Shopping func-
tion".
The temperature in the ap-
pliance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The food products' temper-
ature is too high.
Let the food products tem-
perature decrease to room
temperature before storage.
Many food products are
stored at the same time.
Store less food products at
the same time.
The thickness of the frost is
greater than 4-5 mm.
Defrost the appliance.
The door has been opened
often.
Open the door only if nec-
essary.
The FastFreeze function is
switched on.
Refer to "FastFreeze func-
tion".
There is no cold air circula-
tion in the appliance.
Make sure that there is cold
air circulation in the appli-
ance.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
8.2
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to
"Installation".
3.
If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
9.
INSTALLATION
WARNING!
Refer to Safety chapters.
9.1
Location
Refer to the assembly
instructions for the
installation.
To ensure best performance, install the
appliance well away from sources of heat
such as radiators, boilers, direct sunlight
etc. Make sure that air can circulate freely
around the back of the cabinet.
www.electrolux.com
12
