48
GB
Change of door opening direction
Should the setting-up place or handling demand it,
door-opening direction can be refitted from right-handed
to left-handed.
Following operations are to be done on the basis of fig-
ures and explanations:
Break the circuit of the appliance.
Tilt back the appliance carefully so that the compres-
sor can not touch the floor. It is recommended to ask
another person for help, who can keep the appliance
at this position safely.
Unscrew the adjustable feet situated on both sides
(2 pieces), in addition the screws fixing the lower
door holders (3 pieces) and the screw on the other
side respectively.
Take off the freezer door by pulling it slightly down-
wards.
Unscrew the top door hinge pin of the refrigerator
then screw it back on the other side.
Fit the freezer door on the upper door hinge pin.
Put over the pin in the lower door holding plate in the
direction of the arrow.
Take the door off.
Unscrew the top door holding pin and put it on the
other side.
Put over the handles on the other side and put the
plastic covering nails supplied in the plastic bag of
this instruction book into the holes set free.
Put the appliance to its place, set it level and apply
voltage to it.
In case you do not want to perform the procedures
above, call the nearest brand-mark service.
Technicians will accomplish the refitting expertly for
charge.
Electrical connection
This refrigerator is designed to operate on a 230 V
AC (~) 50 Hz supply.
The plug must be put into a socket with protective
contact. If there is no such, it is recommended to
get an electrician to fit an earthed socket in compli-
ance with standards near the refrigerator.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.02.73 (Low Voltage Directive) and
subsequent modifications,
- 89/336 EEC of 03.05.89 (Electromagnetic
Compatibility Directive) and subsequent modifica-
tions.
