Electrolux EUT 6258, User Manual

electrolux 

29

GB

After a power failure the product will
restart and the quick freeze function
will be switched on. If not switched
off manually, the quick freeze
function will be automatically
switched off 5 hours later. When the
quick freeze function is switched off,
the yellow indicator (C) will go out.

Hints and ideas

In this chapter practical hints and ideas
are given about how to use the
appliance to reach maximum energy
saving and there is environmental
information about the appliance as well.

How to save energy

Avoid putting the appliance in a
sunny place and near anything that
gives off heat.
Be sure that the condenser and the
compressor are well ventilated. Do
not cover the sections where
ventilation is.
Wrap products in tightly closing
dishes or cling film to avoid building
up unnecessary frost.
Avoid products put in the freezer
compartment to touch foods already
frozen.
Do not leave the door open longer
than necessary and avoid
unnecessary openings.
Put warm foods into the appliance
only when they are at room
temperature.
The condenser must be kept clean.

The appliance and
environment

This appliance does not contain gasses
which could damage the ozone layer, in
either its refrigerant circuit or insulation
materials. The appliance shall not be
discarded together with the urban

refuse and rubbish. Avoid damaging
the cooling unit, especially at the
rear near the heat exchanger.
Information on your local disposal
sites may be obtained from your
municipal authorities.
The materials used on this
appliance marked with the sympol

are recyclable.

Maintenance

Defrosting

It is a normal phenomenon that a
part of the internal humidity is
turned into frost and ice during
operation. However, a thick frost or
ice layer has an insulating effect and
thus reduces the freezing
performance leading to rising
internal temperatures and higher
energy consumption and, above a
certain layer thickness, to difficulties
in the opening or sudden break of
the freezer door.
If the formation of frost and ice is not
significant, use the spatula
(accessory) to remove or scrape off
the frost or ice layer.
Please note that the tray shown in
the figure is not an accessory.

If the frost or ice layer is too thick for
removal with the spatula, defrosting
will be necessary. The frequency of
defrosting depends on the actual
use.