3.
Unscrew the screws of the door
bottom hinge.
4.
Take off the appliance door by pulling
it slightly downwards.
5.
Unscrew the top door hinge pin of the
appliance then screw it back on the
other side.
2
1
6.
Fit the appliance door on the upper
door hinge pin.
7.
Remove the lower hinge. Put over the
pin in the direction of the arrow.
8.
Unscrew and install the screw on the
opposite side.
9.
Install the lower hinge on the opposite
side leaving the position of the door
unchanged.
10.
Screw in the one screw in the place
set free on the other side as well as
the adjustable feet (2 pieces).
11.
Remove and install the handle on the
opposite side.
1
2
3
4
CAUTION!
Reposition, level the
appliance, wait for at least
four hours and then connect
it to the power socket.
Do a final check to make sure
that:
• All screws are tightened.
• The magnetic seal
adheres to the cabinet.
• The door opens and
closes correctly.
If the ambient temperature is
cold (i.e. in Winter), the
gasket may not fit perfectly to
the cabinet. In that case, wait
for the natural fitting of the
gasket.
In case you do not want to
carry out the above
mentioned operations,
contact the nearest
Authorised Service Centre.
The Authorised Service
specialist will carry out the
reversibility of the doors at
your cost.
9.5
Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your
domestic power supply.
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
ENGLISH
13
