8
Unplug the appliance before carrying out
any maintenance operation.
Warning
This appliance contains hydrocarbons in its
cooling unit maintenance and recharging
must therefore only be carried out by
authorised technicians.
Defrosting
The freezer compartment will become progressively
covered with frost. This should be removed with the
special plastic scraper provided, whenever the
thickness of the frost exceeds 1/4".
During this operation it is not necessary to switch off
the power supply or to remove the foodstuffs.
However, when the ice becomes very thick on the
inner liner, complete defrosting should be carried out
and it is advisable to carry out this operation when the
appliance is empty.
To carry out complete defrosting proceed as follows:
1.
Remove any stored food, wrap it in several layers
of newspaper and put it in a cool place.
2.
Turn the thermostat control
➁
➁
to the «
■
» setting.
3.
Leave the door open.
4.
Remove the three large drawers.
5.
When defrosting is completed, remove the water
that has collected in the small bottom drawer and
dry the interior thoroughly.
Keep the scraper for future use.
Warning
Never use metal objects for defrosting your
appliance as it may get damaged.
Do not use a mechanical device or any
artificial means to speed up the thawing
process other than those recommended by
the manufacturer.
A temperature increase of the frozen food
shortens its safe storage period.
Periodic cleaning
Never use metal objects for cleaning your appliance
as it may get damaged. Clean the inside with warm
water and bicarbonate of soda. Rinse and dry
thoroughly.
MAINTENANCE
The appliance is equipped with an air inlet filter (1)
and an air outlet duct (2) on the ventilation grid. Keep
clean to guarantee good ventilation and good working
order of the appliance.
The filter can be removed and washed with water, as
follows:
1.
Pinch flaps (a) and (b) with fingers
2.
Pull the filter down.
3.
Pull the filter out.
To replace the filter reverse the process.
An accumulation of dust will affect the performance of
the appliance and cause excessive electricity
consumption.
The structure of the appliance permits cleaning of the
rear zone close to the wall, using a vacuum cleaner.
1.
Remove the plinth (1), then the ventilation grid (2);
2.
Carefully pull the air deflector out (3).
Periods of non-operation
When the appliance is not in use for long periods,
take the following precautions:
remove the plug from the wall socket;
remove all food:
defrost and clean the interior and all accessories;
leave the door ajar to allow air to circulate to prevent
unpleasant smells.
S.I.012
2
1
a
b
S.I.013
3
2
1
