23
www.electrolux.com
Marinatura in busta
Accendere l’apparecchiatura tramite
l’interruttore ON/OFF -
1
- posto alla
sinistra del pannello dei comandi
Inserire nella busta l’alimento con la
marinata di aromi
Inserire la busta nella vasca
Selezionare con i tasti -
9
- i -
10
- uno
dei programmi tra P1 e P5 con
impostazione 99.9% di vuoto e 2
secondi di tempo saldatura.
Chiudere il coperchio e premere il
pulsante Start -
8
- .
Sarà possibile quindi aprire il
coperchio non appena sul display si
visualizza il programma (es. P1)
Conservare poi in frigorifero per 9/12
ore
9.
FUNZIONI AGGIUNTIVE
9.1.
P6 “Vuoto esterno”
È il programma da utilizzare per
l’eliminazione dell’aria all’interno di
speciali contenitori richiudibili
ermeticamente (non in dotazione con
questo prodotto).
Svitare il raccordo di aspirazione posto
all’interno della vasca
Avvitare il raccordo per “vuoto esterno”
Collegare questo raccordo, tramite un
tubo di aspirazione, al contenitore
A coperchio aperto avviare il
programma premendo il pulsante Start
-
8
-.
In questo programma è possibile
impostare solamente il parametro
“vuoto”.
9.2.
P7 “Conditioning program”
È il programma da utilizzare nelle
seguenti situazioni:
Prima di utilizzare la macchina per la
prima volta.
Dopo che questa è rimasta ferma per
un periodo prolungato.
Dopo aver confezionato prodotti con
un’alta percentuale di umidità (es.
minestre e zuppe).
Quando si nota un calo di prestazioni
della macchina (es.: aumenta il tempo
per raggiungere il vuoto o non lo
raggiunge).
Questo programma della durata di circa
3 minuti garantisce una pulizia completa
della pompa eliminando qualsiasi
emulsione di liquidi che si possono
formare nell’olio. Durante l’esecuzione di
questo programma non si deve
confezionare nessun prodotto.
Questo programma non ha variabili
impostabili.
Per avviare il programma eseguire le
seguenti operazioni:
Chiudere il coperchio con la vasca
vuota
Selezionare il programma P7 con i
tasti -
9
- i -
10
-
Premere il tasto Start -
8
-.
Attendere il completamento del ciclo
(circa 3 minuti).
Alla fine del ciclo il display visualizza di
nuovo P7.
A questo punto la macchina è pronta
per l’utilizzo.