Electrolux EW 705 F, Instruction Booklet

Installation

5

Unpacking

All transit bolts and packing must be removed

before using the appliance.

You are advised to keep all transit devices so that
they can be refitted if the machine ever has to be
transported again.

1. Using a spanner, unscrew and remove the two

rear bottom screws. Slide out the two plastic pins. 

2. Lay the machine on its back, taking care not to

squash the hoses. This can be avoided by
placing one of the corner packing pieces between
the machine and the floor.

3. Remove the polystyrene block(s) from the bottom

of the machine. Unscrew and remove the four
feet. Release the two plastic bags.

4. Very carefully slide out the left polythene bag,

removing it towards the right and then downwards.

5. Very carefully slide out the right polythene bag, 

removing it towards the left and then upwards. 

6. Set the machine upright and remove the

remaining rear screw. Slide out the relevant pin.

P1127

P1126

P1123

2

3

1

P0001

P1129

7. Plug all the holes with the plugs which you will

find in the envelope containing the instruction
booklet.

Positioning

Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
units.
Carefully level by screwing the adjustable feet in or
out. Never place cardboard, wood or similar
materials under the machine to compensate for any
unevenness in the floor.

Water inlet

Connect the water inlet hose supplied with the
appliance to a tap with a 3/4" thread.
Do not use already employed inlet hoses.

The other end of the inlet hose which connects to the
machine can be turned in any direction. Simply
loosen the fitting, rotate the hose and retighten the
fitting, making sure there are no water leaks.

P0021

P1088

P1051

P0002

P1128

132983340.qxd  21/10/2005  10:11  Pagina  5    (Nero/Process Black pellicola)