5
ENGLISH
Water drainage
The end of the drain hose can be positioned in three
ways:
Over the edge of a
basin at a height of
between 60 and 90 cm.
To keep the drain hose
spout bent, use the spe-
cial plastic hose guide
supplied with the machi-
ne. Secure it to the wall
with a hook, for example,
or to the tap by means of
a piece of string, to pre-
vent the drain hose moving during the rinsing cycle
thus causing floods.
Into a basin drainpipe branch: the branch must be
above the basin siphon so that the end of the hose is
at least 60 cm from ground level.
Directly into a drainpipe: you are advised to use a
vertical 65 cm high pipe; in any case it should never
be shorter than 60 cm or longer than 90 cm.
The end part of the drain hose must always be venti-
lated, i.e. the internal diameter of the pipe must be
wider than the external diameter of the drain hose.
The drain hose can be extended up to a maximum
length of 180 cm. Use an extension with an internal
diameter at least equal to the diameter of the original
hose and a suitable fitting. The hose extension will
run along the floor and only the part near the draina-
ge point will be raised.
Levelling
Position the appliance and level it by tightening or
loosening one or two of the adjustable feet. Ensure
that the machine is resting securely with all four feet
on the ground. Once the machine has been levelled,
tighten up the lock nuts on all feet with the aid of a
screwdriver.
Electrical connection
Before plugging the appliance into the wall socket,
make sure that:
1. the mains voltage corresponds to the voltage given
in the technical specifications;
2. the meter, fuses, mains power supply and wall
socket can all take the maximum load required.
Make sure that the socket and plug are compatible
without having to use any type of adapter. If neces-
sary, have the domestic wiring system socket repla-
ced.
The electric cable must not be extended. If it is too
short and you do not wish to move the socket, repla-
ce it completely with a longer cable.
Safety standards require the appliance to be
earthed.
The Manufacturer accepts no liability for failure to
observe the above safety precautions.
P0235
P0254
P0509
Summary of Contents for EW 851 F
Page 15: ...124890750 Z ...
