50
Double ring burner cap
The glass in the double ring is designed to fit
loosely. Clean with normal non abrasive glass type
cleaner and thoroughly dry before replacing.
Figure 1 - Cooktop burner head
(All burners except Double ring burner)
Figure 2 - Double ring burner head
(Models equipped with double ring burner only)
Cleaning cooktop, burner
grates, caps and heads
Care and Cleaning
Your appliance is shipped with the burner heads
and burner caps in the correct locations. Before
using your gas appliance be sure to:
● Follow installation instructions before operating.
● Remove all packing tape from cooktop area.
Burner Caps
Should you ever need to remove the burner caps
for cleaning lift the burner cap off the burner
head. Clean heavy soils with an absorbent cloth.
Rinse with a clean, damp cloth and immediately
thoroughly dry including the bottom and inside of
the cap. Do not use harsh abrasive cleaners. They
can scratch the porcelain on the cap. Do not clean
burner caps in dishwasher.
When placing the burner caps, see Important note
below.
IMPORTANT
When placing the burner caps on the cooktop, be
sure the burner caps are seated firmly on top of
burner heads. Improper flame size and uneven
heating may result when any surface burners are
turned ON and the burner caps are not seated
correctly.
Burner heads
Lift the burner cap from the burner head. The
surface burner heads are secured to the cooktop
and must be cleaned in place.
For proper gas flow it may be necessary to clean
the burner heads and slots. To clean, first use a
clean DAMP cloth to soak up any spills. Remove
any food from between the burner slots using a
small nonabrasive brush like a toothbrush and
afterwards wipe using a damp cloth. For stubborn
soils located in the slots, use a small-gauge wire or
needle to clean.
Should you experience ignition problems it may be
that an ignition port hole is partially blocked with
soil (see figs 1 & 2). With the burner head in place,
use a small wire gauge needle or the end of a
paper clip to clear the ignition port or ports.
slots
ignition port
orifice port
Ignition
port
●
To avoid possible burns use care when
cleaning the cooktop. DO NOT attempt to clean
the cooktop whenever the cooktop or burner
heads are still hot.
●
To avoid possible burns DO NOT attempt any
of the following cleaning instructions provided
before turning OFF all of the surface burners
and allow them to cool.
●
To avoid possible burns DO NOT attempt to
operate the surface burners without the burner
caps.