5
30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
Slide the unit into the cabinet. Make sure the center of the unit is
aligned with the center of the cabinet cut-out.
5
Remove the protective channels on each side of the cooktop (if
provided).
6
The metal flange under each side of the cooktop
MUST
be placed
over the cabinet countertop for proper unit support. The cooktop
should
NOT
rest directly on the countertop (see illustration 2) or else
it could cause damage to the cooktop voiding the warranty. Level the
unit if needed.
7
After the
installation, MAKE
SURE that the unit
is supported by
the leveling legs
and NOT by the
cooktop.
1
The counter-top around the cut-out should be flat and leveled (see
hatched area on illustration 1)
H1
H2
H3
H4
Illustration 1
Shave Raised
Edge to
Clear Space
for a 31½"
(80 cm) Wide
Cooktop.
1 ½" Max.
(3,8 cm Max.)
To avoid breakage: Do NOT handle or manipulate
the unit by the cooktop.
2
Before installing the unit,
measure the heights of
the two (2) cabinet sides
(H1-4), front and back
(see illustration 1) from
the floor to the top of the
counter.
3
Level the range using the leveling legs and leveling
device (if equipped) so that the height from the floor
to the underside of the cooktop glass frame is greater
than the tallest cabinet measurement by at least 1/16"
(0,16 cm) (see illustration 2).
4
If the appliance is equipped with leveling device: Remove and discard the two rear
leveling legs (in this case, they are only in place to stabilize the unit for the transport).
Illustration 2
To successfully
install the
range, the
initial level
height from
floor to
underside of
cooktop frame
should be at
least 1/16"
(0,16 cm) taller
than cabinet
sides as
measured in
step 2.
Metal
Flange
Summary of Contents for EW30IS8CRS
Page 40: ...NOTES ...
