5
Installation with cabinets and wall
Minimum clearance to
side wall on either side of
range is 5”
Anti-tip installation
To reduce the risk of tipping of the range, the range
must be secured to the floor by properly installed anti-
tip bracket and screws packed with the range. Failure
to install the anti-tip bracket will allow the range to tip
over if excessive weight is placed on an open door or if
a child climbs upon it. Serious injury might result from
spilled hot liquids or from the range itself.
If range is ever moved to a different location, the anti-
tip brackets must also be moved and installed with the
range.
Instructions are provided for installation in wood or
cement fastened to either the floor or wall. When
installed to the wall, make sure that screws completely
penetrate dry wall and are secured in wood or metal.
When fastening to the floor or wall, be sure that screws
do not penetrate electrical wiring or plumbing.
IMPORTANT SAFETY WARNING!
Anti-tip bracket installation instructions
1.
Locate the Bracket Using the Template - (Bracket
may be positioned on either the left or right side of the
range. Refer to Figs. 24 thru 26 to position the bracket
if template is not available). Mark the floor or wall
where left or right side of the range will be located. If
rear of range is against wall or no further than 1-1/4"
from wall when installed, you may use the wall or floor
mount method. If molding is installed and does not
allow the bracket to fit flush against wall, remove
molding or mount bracket to floor. For wall mount (Fig.
24), locate the bracket by placing the back edge of the
template against rear wall and the side edge of
template on the mark made referencing the side of the
range. Place bracket on top of template and mark
location of the screw holes in wall. If rear of range is
further than 1-1/4" from wall when installed, attach
bracket to the floor. For floor mount (Figs. 24 or 25),
locate the bracket by placing back edge of the
template where the rear of the range will be located.
Mark the location of the screw holes shown in
template.
2.
Drill Pilot Holes & Fasten Bracket - Drill 1/8" pilot
hole where screws are to be located (Fig. 23). If
bracket is to be mounted to the wall, drill pilot hole at
an approximate 20° downward angle. If bracket is to
be mounted to masonry or ceramic floors, drill 3/16"
pilot hole 1-3/4" deep. The screws provided may be
used in wood or concrete material. Use 5/16" nut-
driver or flat head screwdriver to secure the bracket in
place.
3.
Level & Position Range - Level range by adjusting the
(4) leveling legs with a wrench. Note: A min. clearance
of 1/8" is required between bottom of range and
leveling legs to allow room for bracket. Slide range
back into position (Fig. 26). Remove lower panel or
storage drawer to visually check that rear leveling leg
is inserted into and fully secured by the bracket. For
models with a warmer drawer or broiler compartment,
grasp the top rear edge of the range and carefully
attempt to tilt it forward. Use a level to check your
adjustments (Fig. 27).
Fig. 23
INSTALLATION INSTRUCTIONS FOR FREESTANDING DUAL FUEL
Fig. D
