14
Setting for Best Results
Removing and replacing the offset rack
(not illustrated)
•
To remove
pull the oven rack straight forward
until it reaches the stop position. Lift up front of
oven rack slightly and slide out.
•
To replace
, fit the oven rack onto the rack
guides on the oven walls. Tilt the front of the
rack upward slightly and slide the oven rack
completely back into place (not shown).
Removing and replacing the Luxury-
Glide™ oven racks
•
To remove
use thumbs to press in on both left
and right spring-loaded release levers
-Fig. 1-
.
Place the remainder of both hands over the
upper front of the glide rack. While pressing in
on both levers, pull the rack straight out
slightly
and release thumb levers. Using both hands
grasp
both the upper and lower portions
of
the glide rack
-Fig. 1
; pull rack using both hands
straight out until reaching the stop position
-Fig
2-
. At the stop, lift up front of rack slightly and
continue to pull rack away from oven -
Fig 3-
. Be
sure to hold on both upper and lower rack
portions when removing from or handling rack
outside of the the oven - these rack portions
move independently and are difficult to handle
unless held together.
•
To replace
, grasping
both upper and lower
portions
of glide rack, lift and place the rack
resting evenly between the oven cavity walls.
Tilt the front of the rack upward slightly and
slide the rack completely into position. Some
force may be necessary to make sure the oven
rack has snapped completely back into place.
Upper oven racks
NOTE
DO NOT
attempt to close the oven door until all
the oven racks are properly positioned inside
the oven cavity. Be sure the glide oven racks
make contact with the vertical rack sensor
located at the left rear oven cavity wall
(see item
#17, page 9)
.
Fig. 1
Fig. 2
Fig. 3
upper rack
portion
lower rack
portion
Always use potholders or oven mitts when
removing food or adjusting the oven racks. Wait
until the oven has completely cooled if possible.
Oven racks may be
HOT
and may cause burns.
extendable glide rack
