19
FOR THE INSTALLER
Technical information
Dimensions
height with panel
895 mm
height without panel
850 mm
width
397 mm
depth
600 mm
Power supply voltage / frequency
230 V / 50 Hz
Total power absorbed
2300 W (10 A)
Heater rating
1950 W
Water pressure
minimum
0,05 MPa (0,5 bar)
maximum
0,8 MPa (8 bar)
Maximum load
cotton
5,0 kg
synthetics
2,5 kg
wool
1,0 kg
Spinning speed
500 rpm
Electrical consumption (washing at 60°C)
1,30 kWh
This appliance complies with the following EC Directive :
- 72/23/EEC of 19.02.1973 - Low-Voltage Directive
- 89/336/EEC of 03.05.1989 (including Amentment Directive 92/31/EEC) - EMV Directive.
Installation
Unpacking
The parts protecting the inner components of
the machine during transit must all be removed
before using your machine for the first time.
These parts and their securing means should
be kept in case the machine has to be
transported again.
Unpack the appliance. Tilt the appliance
backwards. Give to one of the back corners a
quarter turn. The appliance comes free naturally
out the polystyrene basis. Take away this basis
(fig. 1).
Open the lid of the appliance and remove the
polystyrene and plastic wedges which block
the drum. Close the lid (fig. 2).
On the back part and with a spanner, remove
the two loosened spacers (A) (fig. 3).
The holes which are now visible must be closed
with the plugs (B) provided with the appliance
(fig. 4).
Please ensure that these parts have been
removed from the machine and keep them in
case of next transport (fig. 5).
If you want to keep the alignment of your
appliance with the adjacent cupboards, you
have the possibility to cut the crossbar holding
the hoses located at the back of your washing
machine (fig. 6).
Fig. 1
Fig. 2
Fig 4
Fig 6
B
A
Fig 3
Fig 5
