The drain pump can operate
shortly before the appliance
fills water.
12.7 Starting a programme with
the delay start
1. Touch the Inicio Diferido button
repeatedly until the display shows the
desired delay time. On the display the
indicator shows .
2. Touch the Inicio/Pausa
button.
The appliance door locks and starts the
countdown of the delay start. The display
shows the indicator
.
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start after
the countdown has started
To cancel the delay start:
1. Touch the Inicio/Pausa
button to
pause the appliance. The related
indicator flashes.
2. Touch the Inicio Diferido button
repeatedly until the display shows
and the indicator goes off.
3. Touch the Inicio/Pausa
button
again to start the programme
immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Inicio/Pausa
button to
pause the appliance. The related
indicator flashes.
2. Touch the Inicio Diferido button
repeatedly until the display shows the
desired delay time.
3. Touch the Inicio/Pausa
button
again to start the new countdown.
12.8 The SensiCare System
load detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Inicio/Pausa
button, the SensiCare System starts the
laundry load detection:
1. The appliance detects the load in the
first 30 seconds. In the programmes
where Time Manager is available,
during this phase the two dots
separating hours from minutes are
blinking and the drum rotates shortly.
2. The programme duration could be
adjusted accordingly and could
increase or decrease. After further 30
seconds, the water filling starts.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
The SensiCare detection is
carried out with complete
washing programmes only
and if the programme
duration has not been
reduced.
The SensiCare System is
not available with all
programmes such as :Lana/
Lãs, Aclarado/Enxag.,
Centrif. and programmes
with short cycles.
12.9 Interrupting a programme
and changing the options
When the programme is running, you
can change only some options:
1. Touch the Inicio/Pausa
button.
The related indicator flashes.
2. Change the options. The given
information in the display changes
accordingly.
3. Touch the Inicio/Pausa
button
again.
www.electrolux.com
24
