Electrolux EW6F6268N3, User Manual

8. DIAL AND BUTTONS

8.1 Introduction

The options/functions are

not available with all

washing programmes.

Check the compatibility

between options/functions

and washing programmes in

the "Programme Chart". An

option/function can exclude

another one, in this case the

appliance doesn't allow you

to set incompatible options/

functions.

8.2 On/Off 

Press this button for a few seconds to

activate or deactivate the appliance. Two

different tunes sound while switching the

appliance on or off.
As the Stand-by function automatically

deactivates the appliance after several

minutes to reduce the energy

consumption, you may need to activate

the appliance again.
For more details, refer to Stand-by

paragraph in Daily Use chapter.

8.3 Temp. 

When you select a washing programme,

the appliance automatically proposes a

default temperature.
Touch this button repeatedly until the

desired temperature value appears on

the display.
When the display shows the indicators

, the appliance does not heat the

water.

8.4 Spin

When you set a programme, the

appliance automatically sets the

maximum spin speed allowed, except for

programme Denim. With this option you

can change the default spin speed.
Touch this button repeatedly to:

• Decrease the spin speed. The

display shows only the spin speeds

available for the set programme.

• Activate the No Spin option.

Set this option to deactivate all spin

phases. The appliance performs the

only draining phase of the selected

washing programme. Set this option

for very delicate fabrics. The rinse

phase uses more water for some

washing programmes. The display
shows the indicator 

.

• Activate the Rinse Hold option.

The final spin is not performed. The

water of the last rinse is not drained

out to prevent the fabrics from

creasing. The washing programme

ends with water in the drum.
The display shows the indicator 

.

The door stays locked and the drum

turns regularly to reduce creasing.

You must drain the water to unlock

the door.

At the end of the programme, touch

the Start/Pause button: the appliance

performs the spinning phase and

drains the water.

The appliance empties

the water out

automatically after 18

hours approximately.

• Activate the Night option.

The intermediate and the final

spinning phases are suppressed and

the programme ends with water in the

drum. This helps to reduce creasing.
The display shows the indicator  .

The door stays locked. The drum

turns regularly to reduce creasing.

You must drain the water to unlock

the door.

As the programme is very quiet, it is

suitable for use at night time when

cheaper electricity tariffs are

available. In some programmes the

rinses are performed with more water.

At the end of the programme, touch

the Start/Pause button: the appliance

performs the only draining phase.

The appliance empties

the water out

automatically after 18

hours approximately.

ENGLISH

15