related indicators illuminate on the
display and the given information
changes accordingly.
If a selection is not possible
an acoustic signal sounds
and the display shows
.
10.6 Starting a programme
Touch the Inicio/Pausa
button to start
the programme. It is not possible to start
the programme when the indicator of the
button is off and doesn't flash (e.g. the
door is open).
The related indicator stops flashing and
stays on.
The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
10.7 Starting a programme with
the delay start
1. Touch the Inic.Difer button repeatedly
until the display shows the desired delay
time. On the display the indicator shows
.
2. Touch the Inicio/Pausa
button.
The appliance door locks and starts the
countdown of the delay start. The display
shows the indicator
.
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start after
the countdown has started
To cancel the delay start:
1. Touch the Inicio/Pausa
button to
pause the appliance. The related
indicator flashes.
2. Touch the Inic.Difer button
repeatedly until the display shows
and the indicator goes off.
3. Touch the Inicio/Pausa
button
again to start the programme
immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Inicio/Pausa
button to
pause the appliance. The related
indicator flashes.
2. Touch the Inic.Difer button
repeatedly until the display shows the
desired delay time.
3. Touch the Inicio/Pausa
button
again to start the new countdown.
10.8 The SensiCare System
load detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Inicio/Pausa
button, the maximum declared load
indicator goes off, the SensiCare System
starts the laundry load detection:
1. The appliance detects the load in the
first 30 seconds. During this phase
the Time Manager bars
placed
below the time digits play a simple
animation, the drum rotates shortly.
2. The programme duration will be
adjusted accordingly and could
increase or decrease. After further 30
seconds, the water filling starts.
At the end of the load detection, in case
of drum overload, the indicator
is
flashing in the display:
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Inicio/Pausa
button to start
the programme again. The SensiCare
phase can be repeated up to three times
(see point 1).
ENGLISH
27
Summary of Contents for EW7W3964LB
Page 1: ...EW7W3964LB EN Washer Dryer User Manual ...
Page 46: ...www electrolux com 46 ...
Page 47: ...ENGLISH 47 ...