2. Touch the Start/Pause
button to
start the programme. The SensiCare
estimation starts.
In the display the door locked
indicator comes on.
The display also shows the remaining
programme time.
11.4 At the end of the drying
programme
• The appliance stops automatically.
• The acoustic signals operate (if they
are active).
• In the display
comes on.
• The indicator of the Start/Pause
button goes off. The door locked
indicator goes off and the door
unlocks.
• Press the On/Off button for some
seconds to deactivate the appliance.
After some minutes from
the end of the
programme, the energy
saving function
deactivates the appliance
automatically.
1. Remove the laundry from the
appliance.
2. Make sure that the drum is empty.
After drying phase, clean the
drum, the seal and the inside
of the door with a wet cloth.
12. DAILY USE - DRYING ONLY
WARNING!
Refer to Safety chapters.
This appliance is an
automatic washer dryer.
12.1 Preparation to drying
1. Press the On/Off button for some
seconds to activate the appliance.
2. Load the laundry one item at a time.
3. Turn the programme dial to the
programme suitable for the items to
dry. The appliance defaults to the
washing only mode and the indicator
of the Mode - Wash button is on.
4. Tap on the Mode button twice to
perform drying only. The indicator of
Mode - Dry button illuminates and
the indicator of Mode - Wash
button goes off.
When drying a big amount of
laundry, to have good drying
performances, make sure
that the laundry itself is not
rolled up and that is
uniformly distributed in the
drum.
12.2 Drying - Automatic levels
1. Tap on the Auto Dry button
repeatedly until the display shows the
required dryness level. The indicators
in the display illuminate accordingly:
a.
Iron dry: for cotton items;
b.
Cupboard dry: for cotton and
synthetic items;
c.
Extra dry: for cotton items.
The display shows the drying
programme duration.
2. Touch the Start/Pause
button to
start the programme.
In the display the door locked
indicator comes on.
The display also shows the remaining
programme time.
12.3 Timed Drying
1. Tap on the Time Dry button
repeatedly to set the desired time
value (see the "Timed drying" table
the "Programmes" chapter). The
drying level indicator goes off and
the indicator comes on.
Each time you tap on this button the time
value increases by 5 minutes. The
display shows the set new time value.
www.electrolux.com
30