With some problems, the display shows an alarm code and the
Start/Pause button may flash continuously:
If the appliance is overloaded, remove some items
from the drum and/or keep pressed the door while
touching the Start/Pause button until the indicator
stops flashing (see the picture below).
Problem
Possible solution
The appliance does
not fill with water
properly.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the inlet hose has no kinks, damages or
bends.
• Make sure that the connection of the water inlet hose is
correct.
• Make sure that the filter of the inlet hose and the filter of
the valve are not clogged. Refer to 'Care and cleaning'.
The appliance does
not drain the water.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or bends.
• Make sure that the drain filter is not clogged. Clean the fil‐
ter, if necessary. Refer to "Care and cleaning".
• Make sure that the connection of the drain hose is correct.
• Set the drain programme if you set an option which ends
with water in the tub.
The appliance door
is open or not closed
correctly.
• Make sure that the door is properly closed.
Internal fail. No com‐
munication between
electronic elements
of the appliance.
• The programme was not finished properly or the appliance
stopped too early. Switch the appliance off and on again.
• If the alarm code appears again, contact the Authorised
Service Centre.
www.electrolux.com
46
Summary of Contents for EW9W7449S9
Page 1: ...EW9W7449S9 EN Washer Dryer User Manual ...
Page 53: ......
Page 54: ......
Page 55: ......