4
•
The appliance must be disconnected from the mains
electricity supply during installation, maintenance and
repair work. Ensure that power is not supplied to the
appliance until after it has been installed or until any
maintenance or repair work has been carried out.
•
In areas that may be subject to infestation by
cockroaches or other vermin, pay particular attention
to keeping the appliance and its surroundings in a
clean condition at all times. Any damage that may
be caused by cockroaches or other vermin will not
be covered by the warranty.
•
If the power supply cord is damaged, it must be
replaced by Electrolux, its service agent or similarly
qualified persons in order to avoid creating an
electrical hazard.
IMPORTANT
The power cord can only be routed through the hole in
the bottom of the drawer to avoid touching the back shell
of the appliance.
CAUTION
In order to avoid a hazard due to inadvertent resetting of
the thermal cut-out, this appliance must not be supplied
through an external switching device, such as a timer, or
connected to a circuit that is regularly switched on and
off by the utility.
CLEANING AND CARE
DANGER OF INJURY.
Do not use a steam cleaning appliance to clean
this appliance. The steam could reach electrical
components and cause a short circuit.
Do not immerse the appliance in water or other
liquid when cleaning.
DANGER OF DAMAGE.
Unsuitable cleaning agents can damage the
surfaces of the appliance. Only use domestic
washing-up liquid to clean the appliance.
To avoid damaging the surfaces of your appliance,
do not use:
•
cleaning agents containing soda, ammonia,
acids or chlorides
•
cleaning agents containing descaling agents
•
abrasive cleaning agents, eg. powder cleaners
and cream cleaners
•
solvent-based cleaning agents
•
stainless steel cleaning agents
•
dishwasher cleaner
•
oven sprays
•
glass cleaning agents
•
hard, abrasive sponges and brushes,
eg. pot scourers
•
sharp metal scrapers
Clean and dry the entire appliance after each use.
Allow the appliance to cool down to a safe temperature
before cleaning.
Appliance front and interior cleaning
Remove any soiling immediately. If this is not done,
it might become difficult or impossible to remove and
could cause the surfaces to alter or discolour.
Clean all surfaces with a clean sponge and a solution
of hot water and washing-up liquid. Then dry with a soft
cloth. A clean, damp microfibre E-cloth without cleaning
agent can also be used.
All surfaces are susceptible to scratching. Scratches on
glass surfaces could even cause a breakage. Contact
with unsuitable cleaning agents can alter or discolour
the surfaces.
Anti-slip mat
Remove the anti-slip mat from the drawer before cleaning it.
Clean the anti-slip mat by hand only, using a solution of
hot water and a little washing-up liquid, and then dry with
a cloth.
Do not put the anti-slip mat back into the drawer until it is
completely dry.
NOTE:
Do not wash the anti-slip mat in a
dishwasher. Never place the anti-slip mat in the
oven to dry.