3. Set the hose correctly by loosening
the ring nut.
After positioning the inlet hose, be
sure to tighten the ring nut again to
prevent leaks.
4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied
with the appliance.
The inlet hose must not be lengthened.
If it is too short and you do not wish to
move the tap, you will have to
purchase a new, longer hose specially
designed for this type of use.
Water drainage
The end of the drain hose can be
positioned in three ways:
Hooked over the edge of a sink
using the plastic hose guide
supplied with the machine.
In this case, make sure the end cannot
come unhooked when the machine is
emptying. This could be done by tying
it to the tap with a piece of string or
attaching it to the wall.
P1088
In a sink drain pipe branch.
This
branch must be above the trap so that
the bend is at least 60 cm above the
ground.
Directly into a drain pipe at a
height
of not less than 60 cm and not
more than 90 cm. The end of the drain
hose must always be
ventilated
, i.e.
the inside diameter of the drain pipe
must be larger than the outside
diameter of the drain hose.
The drain hose must not be kinked.
The drain hose may be extended to a
maximum of 4 metres. An additional
drain hose and joining piece is available
from your local Service Centre.
Electrical connection
Information on the electrical connection
is given on the rating plate on the inner
edge of the appliance door and in the
chapter «Technical Data».
P1118
P0022
installation
electrolux
33
132968970.qxd 20/11/2007 10.12 Pagina 33
Summary of Contents for EWF 10570 W
