Electrolux EWF 129442 W, User Manual

vibration, noise and displacement of the
machine during operation.

Caution!

 Never place cardboard,

wood or similar materials under the
machine to compensate for any
unevenness in the floor.

RUBBER FEET KIT (4055126249)

Available from your authorized dealer.
The rubber feet are particularly recommen-
ded on floating, slippery and wooden floors.
Mount the rubber feet to prevent vibration,
noises and displacement of the appliance
during operation.
Read carefully the instructions supplied with
the kit.

WATER INLET

Warning!

This appliance must be

connected to a cold water supply.

1. Connect the water inlet hose supplied

with the machine to a tap with a 3/4"
thread. Always use the hose supplied
with the appliance.

Important!

Do not use the hose from

your previous machine to connect to
the water supply.

2. The other end of the inlet hose which

connects to the machine can be turned
as showed in the picture.
Do not place the inlet hose downwards.
Angle the hose to the left or right de-
pending on the position of your water
tap.

45°

35°

3. Set the hose correctly by loosening the

ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks.

The inlet hose must not be lengthened. If it
is too short and you do not wish to move
the tap, you will have to purchase a new,
longer hose specially designed for this type
of use.

Important!

 Before connecting up the

machine to new pipework or to pipework
that has not been used for some time, run
off a reasonable amount of water to flush
out any debris that may have collected in
the pipes.

WATER DRAINAGE

The end of the drain hose can be posi-
tioned in three ways.
•

Hooked over the edge of a sink

 using

the plastic hose guide supplied with the
machine. In this case, make sure the end
cannot come unhooked when the ma-
chine is emptying. This could be done by
tying it to the tap with a piece of string or
attaching it to the wall.

electrolux 

23