Important!
The Time Manager cannot be
selected with the
Economy
programmes.
The availability of these soil level icons
change according to the type of fabric as
shown in the following chart.
Fabric
Soil Level
Cottons
95°/90°C
X
X
X
X
X
X
60°C/50°C
X
X
X
X
X
X
40°C
X
X
X
X
X
X
30°C
X
X
X
X
X
X
Cold
X
X
X
X
X
X
Synthetics
60°C/50°C
X
X
X
X
40°C
X
X
X
X
30°C
X
X
X
X
Cold
X
X
X
X
Delicates
40°C
X
X
X
X
30°C
X
X
X
X
Cold
X
X
X
X
Altering an option or a running
programme
It is possible to change some options be-
fore the programme carries them out .
Before you make any change, you must
PAUSE the appliance by pressing the but-
ton
8
(if you wish to change the Time Man-
ager option, you must cancel the running
programme and make your selection again).
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to
and then to the new pro-
gramme position. Start the new programme
by pressing the button
8
again. The wash-
ing water in the tub will be not emptied out.
Interrupting a programme
Press the button
8
to interrupt a pro-
gramme which is running, the correspond-
ing green pilot light starts blinking.
Press the button again to
restart
the pro-
gramme.
Cancelling a programme
Turn the selector dial to
to cancel a pro-
gramme which is running.
You can select now a new programme.
Opening the door
After the programme has started (or during
the delay time) the door is locked, if you
need to open it, set first the machine to
PAUSE by pressing the button
8
.
After a few minutes the pilot light
9
goes
out and it is possible to open the door.
If this pilot light remains lit, this means that
the machine is already heating or that the
water level is too high. In any case, do not
try to force the door!
If you cannot open the door but you need
to open it you have to switch the machine
off by turning the selector dial to
O
. After a
few minutes the door can be opened
(pay
attention to the water level and temper-
ature!)
.
After closing the door, it is necessary to se-
lect the programme and options again and
to press button
8
.
At the end of the programme
The machine stops automatically. Three
blinking
0.00
appear on the display and the
pilot light of button
8
goes off. Some acous-
tic signals sound.
If a programme or an option that ends with
water left in the tub has been selected, the
door remains locked to indicate that the wa-
ter must be emptied out before opening the
door.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to
O
.
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button
8
.
At the end of the programme, the door is re-
leased and can be opened. Turn the pro-
gramme selector dial to
O
to switch the ma-
chine off.
Remove the laundry from the drum and care-
fully check that the drum is empty. If you do
not intend to carry out another wash, close
the water tap. Leave the door open to pre-
vent the formation of mildew and unpleas-
ant smells.
12
electrolux
Summary of Contents for EWF 16487 W
