ENGLISH 27
Malfunction Possible Cause
Solution
Too much detergent or unsuitable
detergent (creates too much foam)
has been used.
Reduce the detergent quantity or
use another one.
Reduce the detergent quantity or
use another one.
Redistribute laundry manually in the
drum and start the spin
phase again. Refer to relevant
paragraph in “Positioning” section.
Check whether there are any leaks
from one of the inlet hose fittings. It is
not always easy to see this as the
water runs down the hose; check to
see if it is damp.
Check the water inlet hose
connection.
Too little detergent or unsuitable
detergent has been used.
Increase the detergent quantity
or use another one.
The program is still running.
Wait until the end of washing cycle.
The transit bolts and packing have
not been removed.
Detergent over dose.
Machine unbalance.
Check the correct installation of the
appliance.
The support feet have not been
adjusted.
Check the correct levelling of the
appliance.
The laundry is not evenly distributed
in the drum.
Pause the machine and redistribute
laundry manually.
There is very little laundry in the drum.
Load more laundry.
Unstable floors eg. wooden floors.
Refer to relevant paragraph in
“Positioning” section.
The door lock has not been released.
Wait about 5 minutes.
There is water in the drum.
Select ‘Spin’ program to empty out
the water.
Stubborn stains have not been
treated prior to washing.
Use commercial products to treat
the stubborn stains.
The correct temperature was not
selected.
Check if you have selected the
correct temperature.
Excessive laundry load.
Reduce load.
The drain hose is damaged.
Change it with a new one.
There is
water on
the floor:
Unsatis-
factory
washing
results:
The door
will not
open:
The
machine
vibrates
or is
noisy:
Cycle
time
longer
than
displayed:
This problem may be caused by a
failure of the appliance.
Contact the Service. If you need to
open the door, please read
carefully “Emergency door
opening” on next page.
