19
Adding washing
1.
Press the START/PAUSE key.
•
If “Door locked” and “Pause” are alternately shown in the display, it is no
longer possible to add washing, e. g. when the water level is too high.
•
If “Door openable” and “Pause” are alternately shown in the display, it is
still possible to add washing:
2.
Open the door.
3.
Add washing and close the door again.
4.
Press the START/PAUSE key again. The program continues.
Washing cycle complete/Removing the washing
At the end of the cycle a long acoustic signal sounds 3 times (when the
SOUND setting is NORMAL or LOW) and the messages “Cycle ended” and
“Door openable” appear alternately in the display.
1.
Open the door and remove the washing.
2.
Turn the programme knob to OFF.
3.
After the wash, pull out the detergent dispenser drawer slightly to allow it
to dry. Leave the door slightly open to air the inside of the washing ma-
chine.
If RINSE HOLD
or NIGHT CYCLE
was selected:
After a RINSE HOLD or when a program with NIGHT CYCLE has ended, the
START/PAUSE indicator flashes. “Cycle ended” and “Door locked” appear
alternately in the display.
The water must first be drained:
–
Turn the programme knob to OFF, then to DRAIN and press the START/
PAUSE key (the water is drained without spinning),
or
–
or turn the programme knob to OFF and then to SPIN. Change the spin
speed if necessary and press the START/PAUSE key (the water is drained
and the washing spun).