26
Display shows: “No incoming
water/Check tap & Hose”
Tap turned off.
Turn the tap on.
Filter in the screw connec-
tion of the inlet hose is
blocked.
Turn off the water tap. Unscrew
hose, take out filter and clean it.
Water tap is blocked with
limescale or faulty.
Check the water tap and have it
repaired if necessary.
Washing machine vibrates
when operating or is noisy.
Transit packaging has not
been removed.
Remove transit packaging.
Screw feet not correctly
adjusted.
Adjust feet according to the In-
stallation and Connection in-
structions.
Washing has not been spun.
Only a few large items of
washing in the drum.
Always load the drum as full as
possible. Mix large and small
items.
Water is running out from un-
der the washing machine.
Screw connection on the
inlet hose is leaking.
Screw the inlet hose in firmly.
Drain hose is leaking.
Replace drain hose.
Drain pump cover is not
closed properly.
Close cover properly.
Washing was caught in the
door.
Load washing carefully for the
next wash.
Emergency drain hose is
leaking.
Close off emergency drain hose
properly.
Display shows:
“Warning : EF3”.
The drain pump runs con-
stantly - even when the appli-
ance is switched off.
The Aqua Control anti-
flood system has respond-
ed.
Close the tap, remove the
mains plug from the socket and
inform Customer Service.
Display shows: “Excess De-
tergent”
Probably too much deter-
gent has been used.
Dose detergent exactly as in-
structed by manufacturer.
Display shows:
–
“No drain - check drain
hose/filter” or
–
“Pump Blocked”
Kink in drain hose.
Remove kink.
Maximum pumping height
of 1m exceeded.
Please contact Customer Care
Department.
Drain pump is blocked.
Switch off appliance. Pull out
mains plug.
Clean drain pump. Remove for-
eign bodies from pump hous-
ing.
With connection to sink
outlet: Sink outlet is
blocked.
Clean out sink outlet.
Problem
Possible cause
Remedy