When the program is completed and
the door lock indicator “ ” goes off,
you can open the door.
18 www.electrolux.com
5.10
When The Washing
Program Is Completed, But
There Is Water In The Drum
(Option “Rinse & Hold” is used)
The drum turns regularly to prevent
the creases in the laundry.
You must drain the water to open the door.
The indicator “Start/Pause” flashes to
remind you to drain the water.
-
-
-
-
-
Keep the door partly open, to prevent
the mildew and odours.
Turn off the water tap.
NOTE:
At the end of the program, the time
remaining can suddenly decrease from 7
minutes or less to 0 due to the
overestimated total program time during
the load sensing phase. In some cases
(with perfectly balanced load) the program
time can be shorter than the time
estimated after the load sensing phase is
completed. This is a normal behavior of
the machine and not a cause for concern
as it does not compromise its
performance.
NOTE:
The door lock indicator “ ” is on.
The door stays locked.
1.
To drain the water:
Press the “Start/Pause ” touchpad.
The appliance drains the water and
spins with the maximum spin speed
for selected program.
Alternatively
, before pressing the
“Start/Pause” touchpad, you can press
the “Spin” touchpad to change the
spin speed. You can select “No Spin”,
if you want the machine to only drain
the water.
2.
Press the “On/Off” button to deactivate
the appliance.
3.
After approximately 18 hours, if you do
not press Start/Pause touchpad, the
appliance will drain and spin automati-
cally (except for “Wool” program) .
Press the “On/Off” button to
activate the appliance again.
5.11
AUTO Standby Mode
The AUTO Stand-by option automatically
deactivates the appliance to decrease the
energy consumption when:
You do not press any touchpads for
5 minutes before you press
“Start/Pause”.
After 5 minutes from the end of the
washing program.
Press the “On/Off” button to
activate the appliance again.
