6
FULLY
INTERGRATED
BUILT-IN-
COLUMN INSTRUCTIONS
The unit door seals the installed unit almost
completely, so an air vent must be provided in the
base of the housing. Warmed air must be
conducted via the ventilation shaft to the rear wall
of the housing and then expelled upwards. The
ventilation channels should measure at least 200
square centimeters in cross-section.
A
(mm)
B
(mm)
C
(mm)
D
(mm)
EWK0462X
595
600
110
460
BUILT-IN CABINET INSTRUCTIONS
Make sure your installation does not block the front
ventilation grille.
And be sure the door will open and
close properly in the chosen location.
A
(mm)
B
(mmh)
C
(mm)
D
(mm)
EWK1262X170
1772
620
1768
680
ELECTRICAL CONNECTION
WARNING:
Improper use of the grounded plug
can result in the risk of electrical shock. If the power
cord is damaged, have it replaced by a qualified
electrician or an authorized service center.
All electrical work should be carried out by a suitably
qualified and competent person in accordance with
local and national safety regulations.
Check that the voltage marked on the product
corresponds with your supply voltage.
Connect this appliance to a separate at least 13A
circuit.
Connection should be made via a suitable switched
socket which is easily accessible. For extra safety it
is advisable to install a residual current device (RCD)
with a trip current of 30mA.
Have the receptacle and the circuit checked by a
qualified electrician to ensure that the socket is
grounded correctly.
