Guide to diagnostics of electronic controls EWM10931
2011 SOE/DT-mdm FCPD-dp Quality-tb
30/75
599 73 77-37
Drain the water from the tub.
Are the pressure switch tube and
pressure chamber unobstructed?
(disconnect the tubes and blow into them
to make sure the system is unobstructed)
-(see fig.2 and 8)-
E35: Water level too high
E35
The main circuit board measures a water level, using the electronic pressure
switch, of more than 300 mm for longer than 15 secs.
E35
Checks to perform:
\\\
Clean/change the tube and/or the
pressure chamber and repeat the
diagnostic cycle completely to check
for any further alarms.
Replace
the water fill
solenoid valve
and repeat the
diagnostic cycle
to check for any
further alarms.
Run the
diagnostic cycle
at
phase 9
.
Once the door
has locked, does
the appliance
start to fill
with water?
Change the
analogue
pressure switch
and repeat the
diagnostic cycle
to check for any
further alarms.
Is the wiring
between the main
circuit board and
the analogue
pressure switch
connected
correctly on
both sides?
Replace the main
circuit board and
repeat the
diagnostic
cycle to check
for any
further alarms.
Does the
appliance continue
to fill with
water even
when it is
switched off?
Reconnect
and/or replace
the wiring and
repeat the
diagnostic
cycle to check
for any
further alarms.
Y
E
S
NO
Y
E
S
Y
E
S
NO
NO
NO
Y
E
S
Fig. 2
Fig. 8
Check that all the connectors are correctly inserted
!
If there are burns on the circuit
board, see page 73
!