Guide to diagnostics of electronic controls EWM10931
2011 SOE/DT-mdm FCPD-dp Quality-tb
67/75
599 73 77-37
Checks to perform:
Checks to perform:
Checks to perform:
Checks to perform:
Checks to perform:
EF1
EF1: Drain hose blocked/kinked/too high; drain filter clogged/dirty
EF1
EF2
EF2: Excessive detergent dosing; drain hose kinked/blocked; drain
filter dirty/clogged
EF2
EF3
EF3: Aqua Control device triggered
EF3
EF4
EF4: Water fill pressure too low and solenoid valve open
EF4
EF5
EF5: Unbalanced load, spin phases skipped.
EF5
This warning only appears at the end of the cycle. The appliance detected long drainage phases during
the cycle. (E.g.: More than 20 seconds when draining after rinses). Check/clean the drain filter.
This is an excessive detergent dosing warning. The system detected too much foam was forming during
the drain phases. Advise the Customer to use the correct quantity of detergent and to make sure the
filter and drain circuit are clean.
This warns about the presence of water at the bottom of the appliance. Check for any water leaks
and that the Aqua Control device float is positioned correctly.
Or caused by excessive overheating of the drain pump. Check for any items which may obstruct
the normal operation of the rotor.
This is an unbalanced load warning. The appliance detected an extremely unbalanced load during the
spin phases. Advise the customer to load more washing into the drum and not just individual garments.
Check that all the connectors are correctly inserted
!
Check that all the connectors are correctly inserted
!
Check that all the connectors are correctly inserted
!
Check that all the connectors are correctly inserted
!
It is a warning that the water pressure is too low. If the water pressure is connect, check:
the wiring of the flowmeter and the Flowmeter.
Check that all the connectors are correctly inserted
!
If there are burns on the circuit
board, see page 73
!