12. Opening the door after the
programme has started
First set the machine to PAUSE by pressing the
START/PAUSE button.
If the door does not open, this means that the machine
is already heating, that the water level is above the
bottom edge of the door or that the drum is turning.
If you cannot open the door but you need to open it
you have to switch the machine off by depressing the
ON/OFF button
. After about 3 minutes the door
can be opened (pay attention to the water level and
temperature!). To restart the programme depress
ON/OFF button again after closing the door.
13. At the end of the programme
The machine stops automatically.
If the Rinse hold
has been selected the porthole
remains blocked, the light of the START/PAUSE
button goes off, the pilot lights
and
remain
lit, to indicate that the water must be emptied out
before opening the door.
Turn the programme selector dial to Reset
O
to
switch the machine off .
Press ON/OFF button.
Remove the laundry from the drum and carefully
check that the drum is empty so as to avoid any
forgotten items being damaged in a subsequent
wash (e.g. shrinking) or their colour running into a
load of whites.
If you do not intend to carry out another wash, close
the water tap.
Leave the door open to prevent the formation of
mildew and unpleasant smells.
14
7. Select the required options
The light corresponding to the depressed button
illuminates.
8. Start the programme
To start the selected programme, press the
START/PAUSE button; the corresponding light stops
flashing.
The pilot light corresponding to the wash phase
which is running is on.
The machine starts operating.
9. Altering a programme
You can alter the programme before it starts.
When the programme has started, you can only
reset it by turning the programme selector dial to
O
and then you can select the new programme. Start it
by depressing the START/PAUSE button.
10. Interrupting a programme
Depress the START/PAUSE button to interrupt a
programme which is running, the corresponding
light starts to flash. Depress the same button again
to restart the programme.
11. Cancelling a programme
Turn the selector dial to
O
to cancel a programme
which is running. Now you can select a new
programme.
+
132990770 GB.qxd 11/02/2004 10:33 Pagina 14
