•
Programme progress display
After you have pressed the button
7
, the
display shows the running phase. On the
display you can see the symbol of the se-
lected type of fabric, the current phase, the
duration of the wash programme and the
end of cycle. When the machine performs
the washing phase the display shows also
some animated bubbles that simulate the
moving of the water.
See the below picture:
•
Delay
The selected delay time value (up to 20
hours max.) appears in the position
2.5
of
the display (when the appliance start op-
erating) close to the relevant icon
that it
is lighted-on. The delay time value decrea-
ses every minute.
•
Alarm codes
In the event of operating problems, some
alarm codes can be displayed, for example
«Cannot fill water. Please check that the
tap is open and then press
» (see the
chapter «What to do if...»).
•
End of programme
When the programme has finished the
messages «Door Unlocked» and «Finish-
ed» appear alternatively. The door
icon
remains on to inform that the wash cycle
has finished and the door can be opened.
Stand by mode
If your laundry is not removed during 10
minutes after the programme is finished,
the backlight of the display switches off
and the energy saving system will be en-
abled.
Only the pilot light of the button
7
still
blinks to indicate that you must switch
the appliance off.
Press any buttons will come out from the
energy saving status and you could set
another washing programme or switch
the appliance off.
Programme Option buttons
Depending on the programme, different
functions can be combined. These must
be selected after choosing the desired
programme and before pressing the
button
7
.
Important!
For the compatibility among the
washing programmes and options, refer to
«Washing programmes».
Select the temperature (button 3)
Press the button
3
repeatedly to in-
crease or decrease the temperature, if
you want your laundry to be washed at
a temperature different from the one
proposed by the appliance (position
2.1
in the display).
Important!
To see the maximum and
minimum temperatures allowed for each
washing programmes, refer to «Washing
programmes».
= Cold Wash.
Select the spin speed or No spin or Night
Cycle or Rinse Hold option (button 4)
Press the button
4
repeatedly to change the
spin speed, if you want your laundry to be
spun at a speed different from the one pro-
posed by the appliance.
Important!
The maximum spin speed
provided for the selected washing
programme appears in the display (
2.2
).
By pressing the button
4
it is also possible to
select one of the following options:
No spin
: option eliminates all the spin
phases and increases the number of rinses
in some programmes.
Rinse Hold
: by selecting this option the
water of the last rinse is not emptied out to
prevent the fabrics from creasing. When the
programme has finished the display shows
the icon of the selected programme and the
message «Finished», while on the display
(
2.5
and
2.6
) the end cycle and the current
time appear. The buzzer sounds a short jingle
(if it’s activated), the pilot light of the button
7
is off and the door is locked to indicate that
the water must be emptied out.
To empty out the water, please read the
paragraph «At the end of the pro-
gramme».
electrolux
9
Summary of Contents for EWS 12971 W
Page 1: ...user manual Washing Machine EWS 12971 W EWS 14971 W ...
Page 29: ...electrolux 29 ...
Page 30: ...30 electrolux ...
Page 31: ...electrolux 31 ...
