Electrolux EWT 106415 W, User Manual

1

2

4

3

DRAINAGE FILTER

Clean the filter located at the base of the
appliance regularly :

1

2

3

5

4

7

6

WATER INLET FILTERS

To clean, proceed as follows :

OPERATING PROBLEMS

Numerous checks were carried out on your
appliance before it left the factory. Howev-
er, should you notice a malfunction, please

refer to the sections below before contact-
ing the after-sales service.

Problems

Causes

The washing machine
doesn’t start or doesn’t
fill :

• the appliance isn’t plugged in correctly, the electrical installation isn’t

working,

• the lid of your appliance and the drum shutters aren’t closed firmly,
• the programme start command hasn’t been properly selected,
• there is a power failure,
• the water supply has been cut off,
• the water inlet tap is closed,
• the water inlet filters are dirty,
• a red tab appears on the water inlet hose

1)

.

The appliance fills but
empties straight away :

• the drainage U-piece is fixed too low (see installation section).

The washing machine
doesn’t rinse or doesn’t
empty :

• the drain hose is blocked or bent,
• the drainage filter is obstructed,
• the out of balance detector has been activated : washing is unevenly

distributed in the drum,

• the “Drain” programme or “Night Silence Plus” or “Rinse hold” option

have been selected,

• the height of the drainage U-piece is unsuitable.

You have found water
around the washing ma-
chine :

• too much detergent has caused foam to overflow,
• the detergent is unsuitable for machine washing,
• the drainage U-piece isn’t attached correctly,
• the drainage filter hasn’t been put back in place,
• the water inlet hose is leaking.

10 

electrolux