with
Cotton
,
Synthetic
and
Delicate
pro-
grammes.
Soil Level
Icon
Type of fabric
Intensive
For heavy soiled
items
Normal
For normal soiled
items
Daily
For daily soiled items
Light
For slightly soiled
items
Quick
For very slightly
soiled items
Super Quick
1)
For items used or
worn for a short time
Refresh
1)
2)
For refreshing items
only
Super Re-
fresh
1)
2)
For refreshing a very
few items only
1) We recommend you to reduce the load sizes (see
Washing programmes table).
2) When you select this option the relevant icon appears
just for a while and then it disappears immediately.
Altering an option or a running
programme
It is possible to change some options before
the programme carries them out .
Before you make any change, you must
PAUSE the appliance by pressing the button
8
(if you wish to change the Time Manager
option, you must cancel the running pro-
gramme and make your selection again).
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to
and then to the new pro-
gramme position. Start the new programme
by pressing the button
8
again. The washing
water in the tub will be not emptied out.
Interrupting a programme
Press the button
8
to interrupt a programme
which is running, the corresponding green
pilot light starts blinking.
Press the button again to
restart
the pro-
gramme.
Cancelling a programme
Turn the selector dial to
to cancel a pro-
gramme which is running.
You can select now a new programme.
Opening the door
After the programme has started and
through the delay time the door is locked. If
for any reason, you need to open it, set firstly
the machine to PAUSE by pressing the but-
ton
8
.
After a few minutes it will be possible to open
the door.
If the door remains locked, this means that
the machine is already heating or that the
water level is too high. In any case, do not try
to force the door!
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to
O
. After a few mi-
nutes the door can be opened
(pay atten-
tion to the water level and tempera-
ture!)
.
After closing the door, it is necessary to se-
lect the programme and options again and to
press button
8
.
At the end of the programme
The machine stops automatically. Three
blinking
0.00
appear on the display and the
pilot light of button
8
goes off. Some acoustic
signals sound.
If a programme or an option that ends with
water left in the tub has been selected, the
door remains locked to indicate that the wa-
ter must be emptied out before opening the
door.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to
O
.
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button
8
.
At the end of the programme, the door is re-
leased and can be opened. Turn the pro-
gramme selector dial to
O
to switch the ma-
chine off.
Remove the laundry from the drum and care-
fully check that the drum is empty. If you do
not intend to carry out another wash, close
the water tap. Leave the door open to pre-
vent the formation of mildew and unpleasant
smells.
electrolux
11
Summary of Contents for EWW 126410 W
Page 1: ...user manual Washer dryer EWW 126410 W ...
Page 31: ...electrolux 31 ...
